Roofing in Paramus, NJ
What Roof-Replacement Includes Every job starts with a roof inspection. A roofing contractor checks the roof deck, sheathing, flashing, and ventilation before quoting.
Call 9736364945What You Should See Before You Hire Anyone
- Free roof estimate — a written line-item scope, and no deposit required to get the number.
- Licensed & insured — coverage on the crew and on your property for the duration of the job.
- Roof inspection on every call — deck condition, flashing, ventilation, and gutters evaluated before anyone recommends replacement.
- Debris containment — a dumpster on site, and a magnet sweep of the driveway and lawn after every tear-off.
- Fall protection — scaffold, ladder, and safety harness on any pitch we cannot walk safely.
- Building code compliance — ice-and-water shield, drip edge, and fastener schedule to the code in force in your town.
- Written scope first — you read and approve the plan before a single shingle comes off the roof.
Roofing in Paramus
Paramus weather punishes roofs from two directions. Nor'easters drive wind and freezing rain against the eaves in January, and summer thunderstorms drop hail on the same slopes in July. Between them sit the freeze-thaw cycles that do the quiet damage.
- Ice dams along the eave — water backs up behind a frozen gutter, wicks under the shingle courses, and soaks the felt and decking.
- Wind uplift on wide rakes — mid-century ranch homes from the 1950s and 60s carry long rake edges and few hip corners, so the first course takes the load.
- Hail bruising on older shingle — three-tab shingle sheds granules fast after a summer storm, and the exposed asphalt mat then dries out and splits.
- Low-slope porch and addition roofs — flat sections on the 1970s and 80s colonials and split-levels need a membrane such as TPO or modified bitumen, not shingle.
- Attic ventilation failures — blocked soffit vents and a dead attic fan trap moisture that condenses on the underside of the roof deck.
- Chimney and skylight flashing — the flashing bead and counter-flashing at a chimney or skylight crack well before the surrounding shingles do.
- Newer roofs from the 2000s — the shingle field is often sound while the pipe boots and vent boots have already dried out and peeled.
Housing stock decides the treatment. The ranch homes around Paramus Park and Spring Valley take a full tear-off with new rake boards and fascia, while the split-levels near the Midland Park and Oradell border areas usually need valley and step-flashing work more than new shingles. East Paramus and West Paramus run newer, so there we start with a roof inspection and reseal the boot flashing before anyone quotes a replacement.
What Roof-Replacement Includes
Every job starts with a roof inspection. A roofing contractor checks the roof deck, sheathing, flashing, and ventilation before quoting. You get a roof estimate with a clear scope of work.
- Tear-off: pry bar, roofing shovel, and dumpster for debris
- Deck repair: replace rotted plywood or OSB, check rafter and joist integrity
- Underlayment: synthetic underlayment plus ice-and-water shield at eaves and valleys
- Flashing: step flashing, chimney flashing, apron flashing, boot flashing, counterflashing
- Finish: drip edge, ridge cap, ridge vent, and new sealant at penetrations
Crews set scaffold and ladder access, tie off with a safety harness, and run nail gun and air compressor lines. A roofing square of shingles covers 100 square feet. Torch-down or adhesive-set membrane goes on low-slope sections.
Cleanup means magnet sweeps for nails and fasteners. Gutters and downspouts get cleared. Nothing left behind but the new roofline.
Quality & Materials Standards
Material choice depends on pitch and structure. Steep gable and hip roofs take architectural shingle, dimensional and laminated for depth. Three-tab shingle costs less but wears faster. Wood shake and cedar shake suit certain styles; slate, clay tile, and concrete tile last decades but need truss and ridge beam capacity. Metal panel, standing-seam panel, and corrugated panel handle wind well.
Low-slope sections need membrane: TPO, EPDM, or PVC membrane. Built-up roof and modified bitumen still appear on additions and mansard or gambrel features. Tar and asphalt products age; bitumen-based roofing felt and tar paper are being replaced by synthetic underlayment.
Building code governs fastening schedules, ice-and-water shield placement, and ventilation. Soffit vent and ridge vent must balance. Attic fan or intake vents reduce moisture that causes blistering and uv degradation. Proper installation resists ponding water and seam failure.
Common Roofing Issues in Paramus
What Roof Problems Paramus Homeowners Actually Call About
Two things drive roof failure here: water that cannot drain, and wind that finds every loose edge. The housing stock makes both worse, with long rakes, shallow pitches, and gutters that clog in a single season.
- Ceiling stains that spread after a thaw — the source is usually failed step flashing at a sidewall, not the shingle field. Left alone, water wicks into the sheathing and rots the rafter tails.
- Granule loss in the gutters — asphalt shingle at end-of-life wear sheds its surface, and once the mat is exposed it curls and splits within a season or two.
- Ice dams at the eave — heat escaping through thin insulation melts snow, which refreezes at the cold drip edge and pushes water under the felt. You see the stain in February.
- Sagging between rafters — a roof deck that sags usually means long-term water intrusion and decay in the plywood or OSB, not a framing mistake.
- Cracked pipe boots and boot flashing — rubber collars dry out and peel around plumbing vents. Small repair now, decking replacement later if it waits.
- Ponding on flat sections — a built-up roof or EPDM membrane holding water past 48 hours will blister and delaminate at the seams.
- Loose counter-flashing and coping — on commercial buildings and parapet walls, the metal cap is often the first thing a nor'easter lifts and the last thing anyone checks.
Our Roofing Services in Paramus
Roofing Services Available in Paramus
We cover the full scope here, from a single flashing repair to a complete tear-off and rebuild, on houses and on commercial buildings.
- Roof replacement — full tear-off to the sheathing on the 1950s and 60s ranches, with new underlayment, drip edge, and ridge cap.
- Roof repair — targeted patching of valleys, pipe boots, and chimney flashing where water is getting in right now.
- Storm damage repair — hail bruising and wind uplift documented on the roof before anything is removed.
- Insurance claim assistance — photographs, an adjuster meeting, and a line-item scope you can compare against the settlement.
- Flat roof repair and roof coating — TPO, EPDM, and modified bitumen on porch roofs and commercial buildings, plus a coating that extends a membrane still in good shape.
- Metal roofing — standing-seam panel and corrugated panel for barns, awnings, and canopies.
- Skylight installation — replacing a leaking curb-mounted skylight and re-flashing the opening properly.
- Gutter installation — seamless gutter and downspout sized so runoff clears the foundation instead of the basement wall.
Recent Roofing Projects Near Paramus










Paramus Roofing — Frequently Asked Questions
How much does a roof replacement cost in Paramus?
Price depends on square footage, pitch, how many layers come off, and how much decking has to be replaced. A single-story ranch is the cheapest shape to roof here; a two-story colonial with dormers and valleys takes longer. We hand you a written line-item estimate before any shingle comes off.
How long does a tear-off take?
Most single-family roofs here are stripped and dried in the same day, with shingle and ridge cap finished the next. Steep pitches, a second layer, or heavy sheathing repair add a day. We tarp anything we cannot close before dark.
Will my insurance cover hail or wind damage?
Storm damage is usually covered when it is recent and documented. We photograph the hail bruising and wind uplift, meet the adjuster on the roof, and prepare a line-item scope. You file the claim; we make sure the scope matches the work.
When is the best time of year for roofing work here?
Late spring and early fall. Shingle and self-adhered underlayment seal properly in moderate temperatures, and we avoid the cold snaps that make a winter tear-off slow. Emergency repair runs year round.
What are the first warning signs of an ice dam?
Icicles hanging past the gutter line, a stain spreading across a ceiling corner, and shingle edges lifting at the eave all point the same way. Water is backing up under the courses because the attic is warm and the eave is cold.
Do you roof multi-family and commercial buildings?
Yes. On occupied buildings we contain debris, work during reasonable hours, and treat an active leak as priority one. Flat and low-slope sections get a membrane such as TPO, EPDM, or modified bitumen rather than shingle.